[[Image:Sideshaft.png|frame|right|Side shaft]]
; The cave walls sound hollow. A dangerous side shaft could emergecrack is starting to form on the floor. You will have to find another way. [The cave shudders from some imbalance.] : This message appears when the undermining previous tile being mined shares above, as in a single corner with an existing tunnelsteep upwards dropshaft would be created. To continueThere is no fix for this, adjacent tiles must be mined out before though mining can continue another wall, and changing tunnel direction, may work. Going from the other side down should work. ; A felled tree on this the surface disturbs your operation. : This message appears when a felled tree is laying over the surface of the tilewhere the tunnel will be created. See example on Occurs when mining from the rightinside out.
; Cannot have cave entrances meeting diagonallyAn altar of (deity) on the surface disturbs your operation. : This message appears when an altar is directly above the tile you are trying to mine (possibly near the entrance?). Push the altar to another tile.
; Current tile needs a flat border to correspond to lower part of adjacent cave entrance. : This message appears when there is another cave entrance diagonally. It can be two tiles away from you need to surface mine the bottom slope of the adjacent tile giving to match the message. Mine out slope of the adjacent tilesmine entrance, so you can connect the two entrances by only when creating a tunnelmulti-tile entrance.
; The mountainside Lowering the floor further would risk crumblingmake the cavern unstable. You cannot tunnel here: This message appears when ceiling is too high above the floor.
: Occurs when opening a new tunnel ; The cave walls sound hollow. A dangerous side shaft could emerge. [The cave shudders from the surfacesome imbalance. ] : This message appears when there is already a tunnel to the back or the sides of the entrance tile or if being mined shares a single corner with an existing tunnel is ahead but too far down to connect to. Surface mine down to reduce To continue, adjacent tiles must be mined out before mining can continue on this tile. See example on the slopes, then attempt to tunnel againright.
; The cave walls look very unstable. You cannot keep mining here.
; The cave walls look very unstable and dirt flows in. You would be buried alive.
: This message appears when the tile being mined will break out to the surface, but the surface is not exposed rock. To open the entrance, the rock on the surface must be fully exposed.
; A dangerous crack The ceiling is starting to form on the floor. You will have to find another way. [The cave shudders from some imbalancetoo close.] : This message appears Occurs when undermining previous using concrete to raise a floor tile mined above, as in a steep upwards dropshaft would be created. There that is no fix for this, though mining another wall, and changing tunnel direction, may work. Going less than 20 distance from the other side down should workceiling.
; The ground is too steep to mine at here. You need to make it more flat.
: This message appears occasionally when mining the floor down. The cause is unknown.
; The ground sounds strangely hollow and brittle. You have to abandon the mining operation. : This message appears occasionally when mining when there's already a tunnel on the floor downtile being tunneled. The cause is unknownAn entrance cannot be mined here.
; The ground sounds strangely hollow and brittlemountainside would risk crumbling. You have cannot tunnel here. : Occurs when opening a new tunnel from the surface. This message appears when there is already a tunnel to abandon the mining operationback or the sides of the entrance tile or if a tunnel is ahead but too far down to connect to. Surface mine down to reduce the slopes, then attempt to tunnel again. :
; The mountainside would risk crumbling. You can't open a hole here. : This message appears when when there's already attempting to create a tunnel mine entrance on the a rock tile being tunneledthat is too steep. An entrance cannot be mined here The maximum slope is 270.
; The topology here makes it impossible to mine in a good way.
: This message appears when trying to create a mine entrance on a perfectly flat rock tile. One corner must be lowered with surface mining to continue.<br>This can also occur if both corners nearest the lowest corner are the same height.<br>Has also been reported underground, probably when mining that tile would create a flat mine entrance. Mining downwards may work in this case.
; The mountainside would risk crumbling. You can't open a hole here.
: This message appears when attempting to create a mine entrance on a rock tile that is too steep. The maximum slope is 270.
; There is no space to mine here. Clear the area first.
: This message appears when the tile occupied by the player has 100 a pile of items. Clear the area or move the character onto another tile and make a new pile of shards.
; You fail to produce anything here. The rock is stone hard.
: This message appears when tunneling on the surface. This means the tile you are attempting to excavate is actually an ore vein. There's nothing to do about it, you simply have to make your entrance on another tile. Note that if you make the entrance one tile below the vein, the tunnel will open right into the vein and cannot be extended until the vein is depleted. The best course of action at this point would probably be to mine out a rock tile next to the one you get this message on.
: This message also appears when mining down a floor and roof is too high, Can only be fixed by collapsing all affected tiles and re-mining. (In other words, if you want the tile flat collapse it and re-mine, if you want to lower it collapse all surrounding tiles and re-mine.)
; You hear falling rocks from the other side of the wall. A deep shaft will probably emerge.
: This message appears when there is already another mine nearby, but there is too much of a height difference to connect the two mines.
; You cannot keep mining here. The rock is unusually hard.
: The message appears when attempting to open a tunnel directly onto a vein.
; The roof sounds strangely hollow and you notice dirt flowing in, so you stop mining.
; The water is too deep to mine here.
: This message appears when trying to mine too far under the water table.
: Also occurs when trying to open a tunnel in which the northwest corner of the tile being mined is at or more than 12 dirts below the water table.
; The roof sounds strangely hollow. You must mine the other corners if you want to create an opening.
: This message appears when mining a cave ceiling to the outside tile corners height.
: This message appears to indicates the rock layer above is very close to the ceiling, so there is no more room to mine further.
; You cannot reach the ceiling. The rock sounds hollow, you will need to tunnel to continue : This message appears when trying to [[surface mining|surface mine]] above an open tile underground, and you can't mine are already at the ceiling any higherheight of the mine.
; The rock is too hard to mine. : This message appears when you have tried to mine into a reinforced tile or more rarely, happens with stacked action when the wall breaks before you run out of actions (i.e. trying to mine thin air). ; This tile is protected by the gods. You are can not allowed mine here. : This message appears when a GM protected highway tile above the tile that is being mined. ; There is no space to mine here. Clear the area first. : This message appears when the tile occupied by the player has 100 a pile of items. Clear the area or move the character onto another tile and make a new pile of shards. ; You cannot have cave entrances meeting diagonally. : This message appears when there is another cave entrance diagonally. It can be two tiles away from the tile giving the message. Mine out the adjacent tiles, so you can connect the two entrances by a tunnel. ; You fail to produce anything here. The rock is stone hard. : This message appears when tunneling on the surface. This means the tile you are attempting to excavate is actually an ore vein. There's nothing to do about it, you simply have to make your entrance on another tile. ''Note that if you make the entrance one tile below the vein, the tunnel will open right into the vein and cannot be extended until the vein is depleted. The best course of action at this point would probably be to mine out a rock tile next to the one you get this message on.'': This message also appears when mining down a floor and roof is too high, Can only be fixed by collapsing all affected tiles and re-mining. (In other words, if you want the tile flat collapse it and re-mine, if you want to lower it collapse all surrounding tiles and re-mine.)
; You hear falling rocks from the other side of the wall. A deep shaft will probably emerge. : Deed permissions have disabled miningThis message appears when there is already another mine nearby, and at least one [[spirit templar]] exists but there is too much of a height difference to uphold connect the lawtwo mines.
; You cannot keep mining here. The rock sounds hollow, you will need is unusually hard. : The message appears when attempting to open a tunnel to continue directly onto a vein.
; You cannot reach the ceiling. : This message appears when trying to [[surface mining|surface you can't mine]] above an open tile underground, and you are already at the ceiling height of the mineany higher.
; The rock is too hard You are not allowed to minehere. : This message appears when you Deed permissions have tried disabled mining, and at least one [[spirit templar]] exists to mine into a reinforced tile or more rarely, happens with stacked action when uphold the wall breaks before you run out of actions (i.e. trying to mine thin air)law.
; You are too unskilled to mine here.
: This message appears when trying to surface mine higher than your skill allows. Freedom Formula: 3 x Mining Skill. Epic Formula: 1 x Mining Skill (Not-curved).
; An altar of (deity) on the surface disturbs your operationYou are too unskilled to mine here. : This message appears Occurs when an altar is directly above the trying to mine a rock tile in which you are trying not skilled enough to mine (possibly near the entrance?). Push the altar to another tileThe max slope at which you can mine is 3x your mining skill.
; This tile is protected by You cannot reach the gods. You can not mine hereceiling. : This message appears Occurs when a GM protected highway tile above trying to mine the tile cave ceiling that is being mined. ; A felled tree on the surface disturbs your operation. : This message appears when a felled tree is laying over the surface of the tile where the tunnel will be created. Occurs when mining more than 61 height away from the inside outfloor.
; Current tile needs a flat border to correspond to lower part of adjacent cave entrance.
: This message appears when you need to surface mine the bottom slope of the adjacent tile to match the slope of the mine entrance, only when creating a multi-tile entrance.
; Lowering the floor further would make the cavern unstable.
: This message appears when ceiling is too high above the floor.
[[Category:Babel/M]]